How To Operate The Top And Bottom Cover Forming Machine Correctly?

1. Choose a flat table for the top and bottom cover forming machine, place the machine steadily, and pull the chassis legs apart to make the machine panel easier to observe.
2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap.
3. Insert one end of the power cord into the socket on the rear panel of the chassis, and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.
4. Turn on the "POWER SW." on the rear panel of the chassis, press the "SWITCHING" button on the panel, and wait until the "WARM UP" green indicator light turns on, and the machine can work.
5. Press and hold the "SETTING" button to set to an appropriate value, usually between 0.5-2.0 seconds.
6. Place the sensor head on the container cover and press the start button on the handle. At this time, the "HEATING" red indicator light will light up, indicating that it is heating. Do not move the sensor head away. The "HEATING" red indicator light will turn on. After it goes out, remove the sensor head and wait for the green indicator light of "WARM UP" to light up or the buzzer inside the machine to give a short "beep" prompt before proceeding with the sealing operation of the next container.
7. Check the sealing quality of the top and bottom cover forming machine. According to different materials, diameters of containers and production efficiency, appropriately adjust the "SETTING" button to achieve the best sealing quality.