Basic care and maintenance of the unpacking machine

The carton unpacking machine, also known as the forming machine, refers to the automatic completion of unpacking, forming, and bottom hinge folding. The lower part of the tape is now being pasted, the cardboard boxes are opened, the bottom of the box is folded according to a certain procedure, sealed with tape and then transported to the special equipment of the cartoning machine. Automatic carton forming machines and automatic carton unpacking machines are assembly line equipment for automatically unpacking large quantities of cartons, automatically folding the lower lid, and automatically sealing the bottom tape. The machines are all controlled by PLC + display screen, which is greatly convenient for operation and is essential for automated large-scale production.

Maintenance and maintenance of the transmission mechanism: For cold bending equipment, the friction of the transmission mechanism is very serious. The transmission mechanism we often refer to refers to: transmission chain, transmission gear, reducer, etc. When these parts are operated for a long time with high toughness, the damage rate is accelerated. Therefore, we should pay special attention to the lubrication treatment of these parts. When tools are connected, the gears should be greased every half an hour or so. The reducer should check the remaining oil every ten days. The amount added each time should be based on the actual situation. The amount of oil should be maintained at one-third. Part two.

Maintenance and maintenance of punching molds: The maintenance concept of punching molds is the same as that of cutter molds. When it is found that the mold shell is not sharp enough, the mold shell needs to be flat ground to make it sharper. Maintenance and maintenance of circuits: For some unskilled users, it is inconvenient for circuit problems to occur. Therefore, they should pay more attention to maintaining circuits and do a good job of anti-fouling, waterproofing, and oil-resistant protection. Cables should be carefully protected from damage.

Roller care and maintenance: The rolls need to be coated with anti-rust agent every ten days or so. When the equipment is not scheduled to be used for a long time, the rolls should also be brushed with anti-rust agent. Maintenance and maintenance of the cutter mold: In the area of the cutter mold that causes friction, grease should be added every half an hour during the production process to prevent accelerated damage to the cutter. In addition, when it is found that the burrs of the wound are too large and do not meet the requirements, it is because the wound is not sharp enough and should be handled properly. Otherwise, if it is too serious, the cutter head or mold may be damaged.